SKYBELL HD WON'T SYNC HOW TO
SKYBELL HD WON'T SYNC PASSWORD

You can also use Mocha Ping Lite to ping an IP address. Download the app, open it, and press вЂњNet StatusвЂќ. On Android, you can use this app to find the gateway since it does not show up in the phoneвЂ™s Wi-Fi setting.Д¬onnect to the network that will be used with the SkyBell. Mocha Ping Lite (called Network Ping Lite on iPhone) is a free and easy to use app that can be used to determine the gateway and ping IP Addresses. On iPhone, you can use the phoneвЂ™s settings itself to determine the gateway by connecting to the network you will be using for the SkyBell, then pressing the вЂњiвЂќ and writing down the number after вЂњRouterвЂќ. See next section for further instruction. Alternatively, you can check for 'Default Gateway' on the sticker on the back or bottom of the router. On the вЂњNet StatusвЂќ page it will say 'Gateway' use this number.

For Android, download an application called вЂњMocha Ping LiteвЂќ and press 'Net Status'. Tap the blue вЂњiвЂќ and write down the number after 'Router'. Gateway: On iPhone, connect to the network you are planning on syncing with in Wi-Fi settings. IP range may be only 2-100, so if using 201 doesn't work, try a number between 2 and 100. if the gateway is 192.168.1.x, use 192.168.1.201, if gateway is 10.0.0.x, IP would be 10.0.0.201) The goal is to use an unused IP address and pinging an IP address may be helpful in determining if an IP is in use or not (see below). IP Address: Use the first three numbers from the gateway and 201 for the 4th number (e.g.

SKYBELL HD WON'T SYNC HOW TO

How to Determine the Information Required for an Advanced Sync:

SKYBELL HD WON'T SYNC PASSWORD

Put in your Wi-Fi password and the additional information required. When asked to input your password, please select the 'Advanced' at the top.

Step 4: Once it is flashing red and green, select 'Add a new SkyBell' in your app and follow the on-screen instructions to re-sync your device until after you have selected your network. Within a minute or two, your SkyBell will be flashing red and green. During this time, please delete your SkyBell device from within the SkyBell app if you have not already. Step 3: Once you see the LED flash yellow, please release the SkyBell button. The LED will flash rapid green > red and green > blue > yellow. Step 2: After verifying that information, hard reset the SkyBell by pressing and holding the SkyBell button. Step 1: Determine the information required for Advanced Sync with the instructions below.

Skybell hd won't sync